Most of the reliance users must be knowing that reliance broadband provides a stock modem for free with a new connection, which is good at connecting a single system. but it does not have the wifi capability so the connection can be used only on a single computer and cannot be used for using internet on mobiles,tablets, and other devices , so i decided to use my spare nokia seimens 1600 bsnl wifi modem with reliance broadband. I contacted reliance customer service representatives for some help about configuring my wifi modem, but they only told me the VPI and VCI of reliance (which I'll be explaining later in this post) and recommended me to switch to their wifi plan which was costly, So i was not willing to switch to their wifi plan.Therefore I searched many blogs and searched for many Youtube tutorials but the result was zero, so I decided to put my own efforts, to configure the nokia-seimens modem with reliance . and after some attempts I got success and now I can use the single internet connection on my various devices at the same time.

You might Also Be Interested In: Maximise Your Browsing Protection In Mozilla Firefox !

Steps To Configure Reliance WiFi :

If you are a reliance broadband user, then this tutorial is for you as it can save your a good amount of money.

Remove the stock modem and connect any other wifi supprted modem. (I am using BSNL Nokia siemens 1600 router for this tutorial) as shown in the picture below.
Open any browser and in the address bar type "192.168.1.1" and hit enter to go to the configuration page of the modem. "192.168.1.1" is the default address of most of the routers.A small window will open asking for "username" and "password". The default username and password for the modem is "admin" , so type "admin" in both the fields as shown below and hit enter.
Now you will get the configuration page of modem.Click on "WAN" and remove all the preinstaled settings.
Now Click on "Add" button to install the reliance settings in the modem.
Enter the values in the text boxes as:
Port : 0
VPI : 0
VCI : 35
Service Category: Select "UBR without PCR"
and leave the " 'Quality of Service' and 'Enable VLAN Tagging' " checkboxes remains unchecked and then click "Next" as shown below.
Now the "Connection type" window opens.Select the "MAC Encapsulation Routing (MER)" radio button. and select the Encapsulation mode to be as "LLC/SNAP- BRIDGING" and hit "Next".
Now the WAN IP Configuration window will open.It is recommended to choose the IP, default gateway and, DNS Server to automatically obtain, as there are dynamic.Select the radio buttons as shown below.
In the next page, Check all the Checkboxes in the window as shown below and then click "Next"
A new window will open,showing the complete profile setup that has done as shown below. Just hit "Save" button.
Now in the landing page click on "wireless" to setup the wifi with your broadband connection.Click on "Basic" and then check the checkboxes in front of "enable wireless" and "Clients isolation". Write any SSID (Service Set Identification) of your choice.SSID is nothing but the name of the wifi connection that will be broadcasted to your wifi enabled devices.
Now the wifi connection has been setup successfully, I recommend you to use security key to access your wifi by one of the network authentication scheme available. This can be done by going to the "Security" option.
Click on Reboot>>Save/Reboot. Now your modem will get rebooted, and the custom settings will take into effect just after the reboot.